Power Electronics
The NCP167AMX330TBG is a linear regulator capable of supplying 700 mA output current. Designed to meet the requirements of RF and analog circuits, the NCP167 AMX330TBG device provides low noise, high PSRR, low quiescent current, and very good load/line transients.
INA226 Ultra-Precise I2C Output Current, Voltage and Power Monitor
The INA226 is a current and power monitor chip with high-accuracy ADC and a resolution of 16bit. It features I2C and SMBUS-compatible interfaces for easy integration and monitors both shunt voltage drop and bus voltage drop.
MAX4173FESA Low-Cost High-Side Current Sense Amplifier
The MAX4173FESA is a low-cost, precision, high-side current sense amplifier in the SO-8 Package.
MCP73831T Single-Cell Li-Ion, Li-Polymer Charge Management Controllers
The MCP73831 devices are extremely sophisticated linear charge management controllers for use in situations with limited space and a tight budget. The MCP73831 devices are offered in a 5-Lead SOT-23 configuration.
SP3485 Low Power Half-Duplex RS-485 Transceiver
The SP3485 is a 3.3V powered, half-duplex, low-power RS-485 transceiver that fully meets the requirements of the TIA/EIA-485 standard. The SP3485 includes a driver and a receiver, both of which can be independently enabled and disabled.
IR2104 Half Bridge MOSFET Driver
The IR2104 is a high-speed Half-Bridge gate driver chip that accepts low-power input to output high-power current drives.
Mini360 1.8A DC-DC Adjustable Buck Converter Module
The Mini360 is a small but efficient buck converter module built around the MP2307 from Monolithicpower.
Battery Capacity Tester
A battery capacity tester is used to measure the amount of charge stored in a battery in Ah. It can be used to measure the actual capacity of batteries compared to their rating and to discharge batteries safely.
TP5000 Single-Cell LiPo Charger Module
The TMP5000 module is a breakout board that contains the TP5000 single-cell LiPo battery charging IC and the associated peripheral components that set charge parameters.
TP5100 Lithium Cell Charging Module
The TP5100 is an integrated Lithium battery charger that has a switch mode buck topology. It has all the integrated functions to charge a single or dual cell Lithium battery, along with a few peripheral components.